Slate Effect Cladding

Slate Effect Cladding

Slate Effect Cladding is made to provide a roofing sheet that has the appearance of natural slate but has the advantage of a modern lightweight and amazingly strong building material.

The sheet is .7mm gauge, PVC coated and is extremely easy to fit.  It is ideal for low pitch roofs as it can go as low as 15 degrees.

It is cut to suit the requirements of the roof, and is laid horizontally on the roof, and can be screwed down directly into the rafters so there is no need for batons.   Please see our brochure for full fitting instructions (click the link below).

It is available in 1 colour and that is anthracite grey.

The Slate effect cladding is not insulated, it is a single skin sheet. It is also not available with a nondrip coating.

Gusclad  manufacture a full range of flashings, fixtures and fittings to suit this slate effect cladding.

To view a full brochure on Slate Effect Cladding please click on this link:

Slate Effect At A Glance

• Natural slate effect
• Lightweight & Strong
• .7mm gauge PVC coated
• Minimum pitch required is 15 degrees
• Cut to suit the length of your roof so little waste
• No need for horizontal battons, screw straight to rafter
• Full range of flashings, fixtures and fittings are available to suit.

Gusclad Slate Brochure

Storage:

Products should be covered or stored in a dry place  if not used immediately. This is to prevent the ingress of water, which could damage the cladding.

Delivery:

While Gusclad Ltd will endeavour to meet our delivery estimates. Gusclad Ltd cannot guarantee delivery within the time frames and will not accept responsibility if your order is delivered outside the 5-15 working days time frame. We would strongly recommend that you do not arrange for tradesmen to carry out work on your behalf until your order has actually been delivered. Any shortages on deliveries must be reported to our office within 24hours of delivery.